Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual page 262

Reloading, Shutting Down, Resetting, and Recovering AIP-SSM
–
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
14-6
hw-module module 1 recover configure
Use this command to configure parameters for module recovery. The essential parameters are
the IP address and recovery image TFTP URL location.
Example:
asa# hw-module module 1 recover configure
Image URL [tftp://1.1.1.1/IPS-SSM-K9-sys-1.1-a-5.0-0.15-S91-0.15.img]:
Port IP Address [1.1.1.23]:
VLAN ID [0]:
Gateway IP Address [0.0.0.0]:1.1.1.2
hostname#
asa# show module 1 recover
Module 1 recover parameters...
Boot Recovery Image: No
Image URL: tftp://1.1.1.1/IPS-SSM-K9-sys-1.1-a-5.0-0.15-S91-0.15.img
Port IP Address: 1.1.1.23
Gateway IP Address: 1.1.1.2
VLAN ID: 0
Chapter 14 Configuring AIP-SSM
78-16527-01