Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual page 314

Installing System Images
Image Download Memory Sizing ...................................................
Available Image Download Space: 510MB
0: i8255X @ PCI(bus:0 dev:13 irq:11)
1: i8255X @ PCI(bus:0 dev:14 irq:11)
Using 1: i82557 @ PCI(bus:0 dev:14 irq:11), MAC: 0000.0001.0001
Use ? for help.
rommon>
Verify that IDS-4215 is running BIOS version 5.1.7 or later and ROMMON version 1.4 or later.
Step 4
Note
The current versions are shown in the console display information identified in Step 3.
If necessary, change the port used for the TFTP download:
Step 5
rommon> interface port_number
The port in use is listed just before the rommon prompt. In the example, port 1 is being used as noted by
the text,
Note
Note
Specify an IP address for the local port on IDS-4215:
Step 6
rommon> address ip_address
Note
Specify the TFTP server IP address:
Step 7
rommon> server ip_address
Specify the gateway IP address:
Step 8
rommon> gateway ip_address
Verify that you have access to the TFTP server by pinging it from the local Ethernet port:
Step 9
rommon> ping server_ip_address
rommon> ping server
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
17-12
If IDS-4215 does not have the correct BIOS and ROMMON versions, you must upgrade the
BIOS and ROMMON before reimaging. For the procedure, see
and ROMMON, page 17-13.
Using 1: i82557 @ PCI(bus:0 dev:14 irq:11), MAC: 0000.0001.0001
The default port used for TFTP downloads is port 1, which corresponds with the command and
control interface of IDS-4215.
Ports 0 (monitoring interface) and 1 (command and control interface) are labeled on the back of
the chassis.
Use the same IP address that is assigned to IDS-4215.
Chapter 17 Upgrading, Downgrading, and Installing System Images
Upgrading the IDS-4215 BIOS
.
78-16527-01