Logging In To Aip-Ssm - Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual

Chapter 2 Logging In to the Sensor

Logging In to AIP-SSM

You can log in to AIP-SSM from ASA.
You must initialize the sensor (run the setup command) from ASA. After networking is configured, SSH
Note
and Telnet are available.
To log in to AIP-SSM from ASA, follow these steps:
Log in to ASA.
Step 1
Note
Session to AIP-SSM:
Step 2
asa# session 1
Opening command session with slot 1.
Connected to slot 1. Escape character sequence is 'CTRL-^X'.
You have 60 seconds to log in before the session times out.
Step 3 Type your username and password at the login prompt:
Note
login: cisco
Password:
***NOTICE***
This product contains cryptographic features and is subject to United States
and local country laws governing import, export, transfer and use. Delivery
of Cisco cryptographic products does not imply third-party authority to import,
export, distribute or use encryption. Importers, exporters, distributors and
users are responsible for compliance with U.S. and local country laws. By using
this product you agree to comply with applicable laws and regulations. If you
are unable to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html
If you require further assistance please contact us by sending email to
export@cisco.com.
***LICENSE NOTICE***
There is no license key installed on the system.
Please go to http://www.cisco.com/go/license
to obtain a new license or install a license.
aip-ssm#
78-16527-01
If ASA is operating in multi-mode, use the change system command to get to the system level
prompt before continuing.
The default username and password are both cisco. You are prompted to change them the first
time you log in to AIP-SSM. You must first enter the UNIX password, which is cisco. Then you
must enter the new password twice.
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
Logging In to AIP-SSM
2-7