Cisco Ios Software - Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual

Chapter 15 Configuring IDSM-2
To enable a full memory test, follow these steps:
Log in to the console.
Step 1
Enter privileged mode:
Step 2
cat6k> enable
Enable the full memory test:
Step 3
cat6k> (enable) set boot dev cf:1 3 mem-test-full
Device BOOT variable = cf:1
Memory-test set to FULL
Warning: Device list is not verified but still set in the boot string.
console> (enable) set boot dev hdd:1 3 mem-test-full
Device BOOT variable = hdd:1
Memory-test set to FULL
Warning: Device list is not verified but still set in the boot string.
cat6k> (enable)
The set boot device command can either contain cf:1 or hdd:1.
Step 4 Reset IDSM-2.
For the procedure, see
The full memory test runs.
Note

Cisco IOS Software

Use the hw-module module module_number reset mem-test-full command to enable a full memory
test. The full memory test takes about 12 minutes.
To enable a full memory test, follow these steps:
Log in to the console.
Step 1
Step 2 Enable the full memory test:
router# hw-module module 9 reset mem-test-full
router#
Reset IDSM-2.
Step 3
For the procedure, see
The full memory test runs.
78-16527-01
Resetting IDSM-2, page
A full memory test takes more time to complete than a partial memory test.
Device BOOT variable for reset = <empty>
Warning: Device list is not verified.
Proceed with reload of module?[confirm]
% reset issued for module 9
Resetting IDSM-2, page
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
15-26.
15-26.
Administrative Tasks for IDSM-2
15-25