Catalyst Software; Cisco Ios Software; Catalyst And Cisco Ios Software Commands - Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual

Chapter 15 Configuring IDSM-2

Cisco IOS Software

The reset process takes several minutes.
Note
To reset IDSM-2 from the CLI, follow these steps:
Log in to the console.
Step 1
Reset IDSM-2:
Step 2
router# hw-module module module_number reset [hdd:1 | cf:1]
Note
This example shows the output of the reset command:
router# hw-module module 8 reset
Device BOOT variable for reset =
Warning: Device list is not verified.
Proceed with reload of module? [confirm]
% reset issued for module 8
router#

Catalyst and Cisco IOS Software Commands

This section lists the Catalyst and Cisco IOS software commands that pertain to IDSM-2.
For more detailed information on Catalyst and Cisco IOS software commands, refer to the command
Note
references found on Cisco.com. For instructions on how to locate these documents, refer to the
Documentation Roadmap for Cisco Intrusion Prevention System that shipped with your IDSM-2.
This section contains the following topics:
•
•

Catalyst Software

This section lists supported and unsupported Catalyst Software Commands. It contains the following
topics:
•
•
78-16527-01
If you do not specify either the application partition (hdd:1 the default) or the maintenance
partition (cf:1), IDSM-2 uses the boot device variable.
Catalyst Software, page 15-27
Cisco IOS Software, page 15-29
Supported Supervisor Engine Commands, page 15-28
Unsupported Supervisor Engine Commands, page 15-29
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
Catalyst and Cisco IOS Software Commands
15-27