Converting An In-Use Phone From Sccp To Sip; Converting An In-Use Phone From Sip To Sccp - Cisco 7906G - Unified IP Phone VoIP Administration Manual

Using Cisco Unified IP Phones with Different Protocols
Step 2
Step 3

Converting an In-Use Phone from SCCP to SIP

Converting an In-Use Phone from SIP to SCCP

Step 1
Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 6.1
2-16
Chapter 2
To provision the phone by using the Bulk Administration Tool (BAT), choose
•
the appropriate phone model and choose SIP from BAT.
To provision the phone manually, make the appropriate changes for SIP on
•
the Phone Configuration window in Cisco Unified Communications Manager
Administration.
Refer to the Cisco Unified Communications Manager Administration Guide for
more information about Cisco Unified Communications Manager configuration.
Refer to Bulk Administration Tool Administration Guide for more information
about using BAT.
If you are not using DHCP in your network, configure the network parameters for
the phone.
See the "Configuring Startup Network Settings" section on page 3-14.
Power cycle the phone.
You can use the Bulk Administration Tool (BAT) to convert a phone that is in use
in your network from SCCP to SIP. To access BAT from Cisco Unified
Communications Manager Administration, choose Bulk Administration >
Phones > Migrate Phones > SCCP to SIP. For more information, refer to the
"Migrating Phones" chapter Bulk Administration Tool Administration Guide.
To convert a phone that is in use in your network from SIP to SCCP, perform these
steps. For more information, Cisco Unified Communications Manager
Administration Guide.
Procedure
In Cisco Unified Communications Manager Administration, delete the existing
SIP phone from the Cisco Unified Communications Manager database.
Preparing to Install the Cisco Unified IP Phone on Your Network
OL-14585-01