Converting A New Phone From Sccp To Sip; Converting An In-Use Phone From Sccp To Sip; Converting An In-Use Phone From Sip To Sccp - Cisco 7945G Administration Manual

Using Cisco Unified IP Phones with Different Protocols
•

Converting a New Phone from SCCP to SIP

A new, unused phone is set for SCCP by default. To convert this phone to SIP, perform these steps:
Procedure
Take one of these actions:
Step 1
•
•
•
Refer to Cisco Unified Communications Manager Administration Guide for detailed information about
Cisco Unified Communications Manager configuration. Refer to Cisco Unified Communications
Manager Bulk Administration Guide for detailed information about using BAT.
If you are not using DHCP in your network, configure the network parameters for the phone.
Step 2
See the "Configuring Startup Network Settings" section on page 3-14.
Save the configuration updates and reset the phone.
Step 3

Converting an In-Use Phone from SCCP to SIP

You can use the Bulk Administration Tool (BAT) to convert a phone that is in use in your network from
SCCP to SIP. To access BAT from Cisco Unified Communications Manager Administration, choose
Bulk Administration > Phones > Migrate Phones > SCCP to SIP. For detailed information, refer to
Cisco Unified Communications Manager Bulk Administration Guide.

Converting an In-Use Phone from SIP to SCCP

To convert a phone that is in use in your network from SIP to SCCP, perform these steps. For more
information, Cisco Unified Communications Manager Administration Guide.
Procedure
In Cisco Unified Communications Manager Administration, delete the existing SIP phone from the
Step 1
Cisco Unified Communications Manager database.
Step 2 In Cisco Unified Communications Manager Administration, create the phone as an SCCP phone.
Step 3 Power cycle the phone.
Cisco Unified IP Phone 7965G and 7945G Administration Guide for Cisco Unified Communications Manager 6.1(3)
2-12
Deploying a Phone in an SCCP and SIP Environment, page 2-13
To auto-register the phone, set the Auto Registration Phone Protocol enterprise parameter in
Cisco Unified Communications Manager Administration to SIP.
To provision the phone by using the Bulk Administration Tool (BAT), choose the appropriate phone
model and choose SIP from BAT.
To provision the phone manually, make the appropriate changes for SIP on the Phone Configuration
window in Cisco Unified Communications Manager Administration.
Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network
OL-17755-01