Adding Phones With Auto-Registration - Cisco 7906G - Unified IP Phone VoIP Administration Manual

Adding Phones to the Cisco Unified Communications Manager Database

Adding Phones with Auto-Registration

Note
Note
Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 6.1
2-12
Chapter 2
By enabling auto-registration before you begin installing phones, you can:
Add phones without first gathering MAC addresses from the phones.
•
Automatically add a Cisco Unified IP Phone to the Cisco Unified
•
Communications Manager database when you physically connect the phone
to your IP telephony network. During auto-registration, Cisco Unified
Communications Manager assigns the next available sequential directory
number to the phone.
• Quickly enter phones into the Cisco Unified Communications Manager
database and modify any settings, such as the directory numbers, from
Cisco Unified Communications Manager.
Move auto-registered phones to new locations and assign them to different
•
device pools without affecting their directory numbers.
Cisco recommends you use auto-registration to add less than 100 phones to your
network. To add more than 100 phones to your network, use the Bulk
Administration Tool (BAT). See the
page 2-14.
Auto-registration is disabled by default. In some cases, you might not want to use
auto-registration; for example, if you want to assign a specific directory number
to the phone, or if you plan to implement authentication or encryption, as
described in Cisco Unified Communications Manager Security Guide. For
information about enabling auto-registration, refer to "Enabling
Auto-Registration" in the Cisco Unified Communications Manager
Administration Guide.
When you configure the cluster for mixed mode through the Cisco CTL client,
auto-registration is automatically disabled. When you configure the cluster for
non-secure mode through the Cisco CTL client, auto-registration is automatically
enabled.
Related Topics
Adding Phones with Auto-Registration and TAPS, page 2-13
•
Preparing to Install the Cisco Unified IP Phone on Your Network
"Adding Phones with BAT" section on
OL-14585-01