Cisco 7906G - Unified IP Phone VoIP Administration Manual page 90

Configuring Security on the Cisco Unified IP Phone
Refer to Cisco Unified Communications Manager Security Guide for more
information.
To configure an LSC on the phone, follow these steps:
Procedure
Obtain the CAPF authentication code that was set when the CAPF was
Step 1
configured.
From the phone, press the Applications Menu button and choose Settings >
Step 2
Security Configuration.
Note
Step 3 Press **# to unlock settings on the Security Configuration menu. (See the
"Unlocking and Locking Options" section on page 4-4
locking and unlocking options.)
Note
Scroll to LSC and press the Update softkey.
Step 4
The phone prompts for an authentication string.
Enter the authentication code and press the Submit softkey.
Step 5
The phone begins to install, update, or remove the LSC, depending on how the
CAPF was configured. During the procedure, a series of messages displays in the
LSC option field in the Security Configuration menu so that you can monitor
progress. When the procedure completes successfully, the phone will display
Installed or Not Installed.
The LSC install, update, or removal process can take a long time to complete. You
can stop the process at any time by pressing the Stop softkey from the Security
Configuration menu. (Settings must be unlocked before you can press this
softkey.)
Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 6.1
3-18
You can control access to the Settings Menu by using the Settings Access
field in the Cisco Unified Communications Manager Administration
Phone Configuration window. For more information, see
Cisco Unified Communications Manager Administration Guide.
If a Settings Menu password has been provisioned, SIP phones present an
"Enter password" prompt after you enter **#.
Chapter 3 Setting Up the Cisco Unified IP Phone
for information using
OL-14585-01