Converting A New Phone From Sccp To Sip; Converting An In-Use Phone From Sccp To Sip - Cisco 7970G Administration Manual

Using Cisco Unified IP Phones with Different Protocols

Converting a New Phone from SCCP to SIP

Step 1
Step 2
Step 3

Converting an In-Use Phone from SCCP to SIP

Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.1 (SIP), Cisco Unified IP Phones
2-18
Chapter 2
A new, unused phone is set for SCCP by default.
To convert this phone to SIP, perform these steps:
Procedure
Take one of these actions:
To auto-register the phone, set the Auto Registration Phone Protocol
•
parameter in Cisco Unified CallManager Administration to SIP.
To provision the phone using the Bulk Administration Tool (BAT), choose
•
the appropriate phone model and choose SIP from the BAT.
To provision the phone manually, make the appropriate changes for SIP on
•
the Phone Configuration page in Cisco Unified CallManager Administration.
Refer to Cisco Unified CallManager Administration Guide for detailed
information about Cisco Unified CallManager configuration. Refer to Cisco
Unified CallManager Bulk Administration Guide for detailed information about
using the BAT.
If you are not using DHCP in your network, configure the network parameters for
the phone.
See the "Configuring Startup Network Settings" section on page
Power cycle the phone.
You can use the Bulk Administration Tool (BAT) to convert a phone that is in use
in your network from SCCP to SIP. To access BAT from Cisco Unified
CallManager Administration, choose Bulk Administration > Phones > Migrate
Phones > SCCP to SIP. For detailed information, refer to the "Migrating Phones"
chapter Cisco Unified CallManager Bulk Administration Guide.
Preparing to Install the Cisco Unified IP Phone on Your Network
3-17.
OL-11524-01