Deploying A Phone In An Sccp And Sip Environment; Determining The Mac Address Of A Cisco Unified Ip Phone - Cisco 7906G - Unified IP Phone VoIP Administration Manual

Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network
Step 2
Step 3

Deploying a Phone in an SCCP and SIP Environment

Determining the MAC Address of a Cisco Unified
IP Phone
Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 6.1
OL-14585-01
In Cisco Unified Communications Manager Administration, create the phone as
an SCCP phone.
Power cycle the phone.
To deploy Cisco Unified IP Phones in an environment that includes SCCP and SIP
and in which the Cisco Unified Communications Manager Auto-Registration
parameter is SCCP, perform these general steps:
Set the Cisco Unified Communications Manager auto_registration_protocol
1.
parameter to SCCP.
From Cisco Unified Communications Manager Administration, choose
System > Enterprise Parameters.
Install the phones.
2.
Change the Auto Registration Protocol enterprise parameter to SIP.
3.
Auto-register the SIP phones.
4.
Several of the procedures that are described in this manual require you to
determine the MAC address of a Cisco Unified IP Phone. You can determine the
MAC address for a phone in any of these ways:
• From the phone, press the Applications Menu button, then choose
Settings > Network Configuration, and look at the MAC Address field.
Look at the MAC label on the back of the phone.
•
Display the web page for the phone and click the Device Information
•
hyperlink.
For information about accessing the web page, see the
Page for a Phone" section on page

Determining the MAC Address of a Cisco Unified IP Phone

8-2.
"Accessing the Web
2-17