Cisco 7906G - Unified IP Phone VoIP Administration Manual page 110

Device Configuration Menu
Table 4-5 SIP General Configuration Menu Options
Option
Preferred CODEC
Out of Band DTMF
Register with Proxy
Register Expires
Phone Label
Enable VAD
Start Media Port
End Media Port
Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 6.1
4-18
Description
Displays the CODEC to use when a call
is initiated.
Displays the configuration of the
out-of-band signaling (for tone detection
on the IP side of a gateway). The
Cisco Unified IP Phone (SIP) supports
out-of-band signaling by using the AVT
tone method. Valid values are none, avt,
and avt_always.
Displays if the phone must register with
a proxy server during initialization.
Displays the amount of time, in seconds,
after which a registration request expires.
Displays the text that is displayed on the
top right status line of the LCD on the
phone. This text is for end-user display
only and has no effect on caller
identification or messaging.
Displays if voice activation detection
(VAD) is enabled.
Displays the start Real-Time Transport
Protocol (RTP) range for media.
Displays the end Real-Time Transport
Protocol (RTP) range for media.
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
To Change
Display only—cannot configure.
Display only—cannot configure.
Display only—cannot configure.
From Cisco Unified
Communications Manager
Administration, choose Device >
Device Settings > SIP Profile.
Display only—cannot configure.
From Cisco Unified
Communications Manager
Administration, choose Device >
Device Settings > SIP Profile.
From Cisco Unified
Communications Manager
Administration, choose Device >
Device Settings > SIP Profile.
From Cisco Unified
Communications Manager
Administration, choose Device >
Device Settings > SIP Profile.
OL-14585-01