Launch A Profile Update By Using A Browser Command; Rebooting A Phone By Using A Browser Command - Cisco 521SG - Unified IP Phone VoIP Administration Manual

Provisioning
Updating Profiles and Firmware
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide

Launch a Profile Update by using a Browser Command

Cisco SPA IP phones can synchronize to specific profiles stored on a remote
server. The phone resyncs only when it is idle. The update is attempted
automatically after the call is complete.
To update the phone profile, enter this command:
http://phone-ip-addr/admin/resync?protocol://server-
name[:port]/profile-pathname
phone-ip-addr is the IP address of the phone.
•
Parameter following resync? defaults to the Profile Rule setting on the
•
web server Provisioning page.
protocol defaults to TFTP.
•
server-name defaults to the host requesting the URL.
•
port defaults to:
•
- 69 for TFTP
- 80 for HTTP
- 443 for HTTPS
profile-pathname defaults to the path for the new synchronization
•
profile (for example, http://192.168.2.217admin/resync?tftp://
192.168.2.251/spaconf.cfg).

Rebooting a Phone by using a Browser Command

You can remotely reboot a Cisco IP phone by entering a command in a web
browser URL field.
To reboot a phone, enter the following command:
http://phone-ip-address/admin/reboot
phone-ip-addr is the IP address of the phone.
•
6
167