Vlan Settings - Cisco 521SG - Unified IP Phone VoIP Administration Manual

Cisco SPA IP Phone Field Reference
System Tab
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide
Parameter
Debug Level
Primary NTP Server
Secondary NTP Server
Enable Bonjour
(Cisco SPA525G or
Cisco SPA525G2 only)

VLAN Settings

Not applicable to the Cisco WIP310.
Parameter
Enable VLAN
VLAN ID
Enable PC Port VLAN
Tagging
Description
The debug level from 0-3. The higher the level, the
more debug information is generated. Zero (0)
means no debug information is generated. To log
SIP messages, you must set the Debug Level to at
least 2.
Defaults to 0.
IP address or name of primary NTP server.
IP address or name of secondary NTP server.
Enable Bonjour networking that is used by Office
Manager and Cisco Configuration Assistant to
discover the Cisco IP phones. Choose yes to
enable or no to disable.
Description
Choose Yes to enable VLAN. Choose no to
disable.
If you use a VLAN without CDP (VLAN enabled
and CDP disabled), enter a
phone. Note that only voice packets are tagged
with the VLAN ID. Do not use 1 for the VLAN ID.
Enables VLAN and priority tagging on the phone
data port (802. 1 p/q). This feature facilities tagging
of the VLAN ID (802. 1 Q) and priority bits (802. 1 p)
of the traffic coming from the PC port of the IP
phone.
Defaults to No. Choose Yes to enable the tagging
algorithm.
A
VLAN ID for the IP
227