Cisco 521SG - Unified IP Phone VoIP Administration Manual page 198

Configuring Dial Plans
About Dial Plans
NOTE
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide
Digit Sequence
,
(comma)
!
(exclamation point)
*xx
S0 or L0
P
The Cisco SPA9000 and the Cisco IP phones implicitly append the vertical code
sequences entered in the regional parameter settings to the end of the dial plan.
Likewise, if Enable_IP_Dialing is enabled, IP dialing is also accepted on the
associated line.
Function
An intersequence tone played (and placed)
between digits plays an outside line dial tone. For
example:
9, 1xxxxxxxxxx
An outside line dial tone is sounded after the user
presses 9. The tone continues until the user
presses 1.
Prohibits a dial sequence pattern. For example:
1900xxxxxxx!
Rejects any 11-digit sequence that begins with
1900.
Allows a user to enter a 2-digit star code.
For Interdigit Timer Master Override, enter S0 to
reduce the short inter-digit timer to 0 seconds, or
enter L0 to reduce the long inter-digit timer to 0
seconds.
To pause, enter P, the number of seconds to pause,
and a space. This feature is typically used for
implementation of a hot line and warm line, with a
0 delay for the hot line and a non-zero delay for a
warm line. For example:
EXAMPLE: P5
A pause of 5 seconds is introduced.
8
197