Test Your Microphone; Update Your Cisco Headset Firmware With A Cisco Ip Phone; Configure A Headset On The Phone - Cisco 7800 Series Accessories Manual

Headsets
By default, your phone follows the behavior of the phone ringer settings. Select On if you want to always
hear the phone ring when you have an incoming call. If you select Off, you won't hear any ring through your
headset when there is an incoming call.
Step 4 Select Set to apply your settings.

Test Your Microphone

Check your microphone when you first install it, and before you begin a call.
Procedure
Step 1 Press Applications
Step 2
Select Accessories and then your headset.
Step 3 Navigate to Setup > Microphone > Test.
Step 4
Press Record and speak into the microphone.
Step 5 Press Stop rec when you finish speaking.
Step 6
Press Play to review your test recording.

Update Your Cisco Headset Firmware With a Cisco IP Phone

You can update your headset software on any supported Cisco IP Phone. During a headset firmware upgrade,
you can view the progress on your phone screen.
Procedure
Step 1
Connect your headset to a Cisco IP Phone.
Note
Step 2
If the headset does not automatically begin to update, restart the phone. The phone downloads the latest headset
version file when the phone restarts and uploads it to the headset.

Configure a Headset on the Phone

After you have connected the headset, you may have to configure it on your phone.
If you have a Cisco headset with a USB adapter, then follow the steps in
page 37
.
You can only upgrade the Cisco Headset 730 on IP Phones through the USB cable.
Cisco IP Phone 7800 and 8800 Series Accessories Guide for Cisco Unified Communications Manager
Test Your Microphone
Cisco Headset Customization, on
41