Ring Script - Cisco 521SG - Unified IP Phone VoIP Administration Manual

Configuring Regional Parameters and Supplementary Services
Scripting for Cadences, Call Progress Tones, and Ring Tones
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide
• Number of Segments = 4
• Segment 1: On=0.38s, Off=0s, with Frequency 1
• Segment 2: On=0.38s, Off=0s, with Frequency 2
• Segment 3: On=0.38s, Off=0s, with Frequency 3
• Segment 4: On=0s, Off=4s, with no frequency components
• Total Tone Length = 20s

Ring Script

A RingScript is a mini-script that describes a ring tone. Syntax:
n=ring-tone-name;w=waveform-id-or-path;c=cadence-
id;b=break-time;t=total-time
ring-tone-name identifies this ring tone. This name appears on the Ring
Tone menu of the phone. The same name can be used in a SIP Alert-Info
header in an inbound INVITE request to tell the phone to play the
corresponding ring tone. The name should contain the same characters
allowed in a URL only.
waveform-id-or-path is the index of the desired waveform to use in this
ring tone. The built-in waveforms are:
- 1 = Classic phone with mechanical bell
- 2 = Typical phone ring
- 3 = Classic ring tone
- 4 = Wide-band frequency sweep signal
This field can also be a network path (url) to download a ring tone data file
from a server on-the-fly. In this case, the syntax of the field is:
w=[tftp://]hostname[:port]/path
cadence-id is the index of the desired cadence to play the given
waveform. 8 cadences (1–8) as defined in <Cadence 1> through <Cadence
8>. Cadence-id can be 0 If w=3,4, or an url. Setting c=0 implies the on-time
is the natural length of the ring tone file.
break-time specifies the number of seconds to break between two
bursts of ring tone, such as b=2.5.
7
176