Cisco 521SG - Unified IP Phone VoIP Administration Manual page 224

Cisco SPA IP Phone Field Reference
System Tab
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide
Parameter
SPA525-protocol
(Cisco SPA525G or
Cisco SPA525G2 only)
SPA525-auto-detect-sccp
(Cisco SPA525G or
Cisco SPA525G2 only)
SPA525-readonly
(Cisco SPA525G or
Cisco SPA525G2 only)
Phone-UI-user-mode
Description
Allows you to choose the type of protocol for the
phone:
• SIP—Session Initiation Protocol. Choose if the
phone is used with a SIP call control system, such
Cisco SPA9000
as the
from another provider such as BroadSoft or
Asterisk.
• SPCP—Smart Phone Control Protocol. Choose if
the phone is used with a Cisco Unified
Communications Series server, such as the Cisco
Unified Communications 500 Series for Small
Business.
Choose if the phone should automatically detect
the type of protocol used on the network to which
it is connected. If set to yes, the phone
automatically discovers if it is connected to a call
control system using SPCP.
If set to yes, the Signaling Protocol and Auto
Detect SCCP Settings on the phone are read only.
If set to no, the above settings on the phone can
be changed by the end user.
Allows you to restrict the menus and options that
phone users see when they use the phone
interface. Choose yes to enable this parameter
and restrict access. The default is no.
Specific parameters are then designated as "na"
or "ro" using provisioning files. Parameters
designated as "na" will not appear on the phone
interface. Parameters designated as "ro" will not
be editable by the user.
A
or a SIP call control system
223