Xerox 6030 User Manual page 377

Data connection error
Status: A data connection error occurred during file transfer.
Action: Establish the connection and transfer the file again.
Directory non existent or syntax error
Status: A non-existent directory (logical printer) is specified.
Action: Specify the correct directory (logical printer).
Error in input file
Status: An error occurred in an output file during transfer.
Action: Establish the connection and transfer the file again.
File "xx" not found or permission problem
Status: Failed to open or read a parameter file corresponding to the logical printer
specified by the ls command.
Action: Wait a few moments and try again.
Insufficient storage space in system, please try later
Status: Cannot transfer data because the hard disk is full.
Action: Wait until a space is reserved on the hard disk, and start transfer again.
Invalid command
Status: An invalid command is received.
Action: Transfer the correct command.
Job queue is full, please try later
Status: Cannot receive data because the job queue is full.
Action: Wait a few moments and try again.
Local resource failure: Xerox 6030/6050 WF is busy
Status: Cannot accept data transfer because the system is overloaded.
Action: Check the system for a media-out or media jam error. Wait a few moments
and try again. If the error occurs frequently, restart the Xerox 6030/6050 Wide
Format .