System Parameter Setup (Print Services On Web); (Print Services On Web)154; 8.3 Communication Parameter Setup - Xerox 6030 User Manual

8.5
System Parameter Setup
(Print Services on Web)
The system parameters listed below can be set up from Print Services on Web.
Priority
Replot
Print Density
Paper Width for
Special A
(SPA PAPER
WIDTH)
These procedures are performed on the Administrator page.
Refer to "8.3 Communication Parameter Setup (Print Services on Web)" for
information about setting up the [TCP/IP], [Serial], [Centro], [VPI], and [SNMP]
selections in the [System Parameters] menu on the Properties tab.
The parameter nomenclature on Print Services on Web will sometimes differ
from the nomenclature on the printer control panel. The printer control panel
nomenclature appears in bold type in the table below.
Menu Item
Determines which of the following should be set up as the
standard for determining the priority sequence of job output
for the same job.
[ QIN_FOPEN ]
[ QIN_FCLOSE ] Time to end data transfer
Enables or disables the reprinting feature.
Sets up the default print density level. The density setting is
a numeric value between -99 and 99.
Sets the paper width for SP. JIS/ISO A paper. The default
value is [SP A1].
[SP. A1]
[SP. A2]
Description
Time to start data transfer
620 or 625mm
435 or 440mm