Poor Image Quality - Xerox 6030 User Manual

13.2

Poor Image Quality

Perform the following corrective measures if the copies or prints display one of the
image quality defects listed below.
Image Quality Defect
Streaks or black spots
appear on the print
The print displays excessive
background
Some parts of the image
did not print or are
blurred
The machine will not copy
The copy/print is wrinkled
Corrective Measure
Check the scanner to determine if it is dirty.
• Clean the scanner. Refer to
in
Scanner" "Chapter 12 Maintenance"
Verify that the image density setting is correct.
Check the quality of the original.
• Reduce the image density setting.
• Increase the background suppression setting.
Verify that the image density setting is correct.
• Change the image density
Determine if the media is damp.
Switch on
• the paper heater switch, if it is off.
• Replace the damp media with new media.
• Change the sharpness setting.
Confirm that the size of the document does not
exceed the limit.
• Check the length and width of the document. If the
size exceed the limit, split the document and copy it
in sections.
• Verify that sufficient memory is installed.
Verify that the image side of the document is inserted
correctly (facing down).
• Insert the document in the correct orientation. Verify
that the correct features have been selected.
• Check the feature settings on the copier control
panel.
Determine if the media is damp.
Switch on
• the paper heater switch, if it is off.
• Replace the damp media with new media.
"12.2 Cleaning the
.
setting.