Xerox 6030 User Manual page 253

Description of the Configuration List Contents
The contents of configuration list are explained below.
Displayed Item
H/W CONFIG Model
Software Version
RAM Total
Segment Memory
Work Memory
Frame Memory
Harddisk
Option H/W
Finisher Model
S/W CONFIG PostScript
Network Scan
Key Install Key
PORT SETTING ETHERNET
TCP/IP
SNMP
SYSTEM All
PARAMETER
Description
Product name
Installed version of the printer software
Displays the amount of memory installed in the
printer.
Displays the capacity of the area where spooled
print data is stored during print processing.
Displays the capacity of the area used for
running the controller software.
Displays the capacity of the image memory (the
area in which images developed into bit maps
are stored.)
Displays the model number of the hard disk on
which the input data are spooled.
Additional installed hardware device(s), such as
a folder, stacker, etc.
Model number of the finisher
Enabled software option
Disabled software option
Installation key number for the installed and
enabled software option
Ethernet settings
TCP/IP port settings
SNMP status
The left column lists the available system
parameters.
The center column lists the current system
parameter settings.
The right column lists the possible settings for
each of the system parameters.