Xerox 6030 User Manual page 219

Serial
The serial communication parameters are listed below.
Default Parser
Logical printer
number
Handshake
Baud Rate
Parity
Data Bit
Stop Bit
EOP Timeout
Timeout Value
Output
Response
The communication parameter nomenclature on the printer control panel will
sometimes differ from the nomenclature on Print Services on Web. The Print
Service on Web nomenclature appears in bold type in the table below.
Menu Item
The default setting is
Sets up a logical printer number to be use if a logical printer is
not defined in the print job.
Selects the handshake method from the following choices.
The default setting is [XON/XOFF].
[ XON/XOFF ] Handshake using the XON/XOFF protocol.
[ HARDWARE ] Handshake using the hardware.
[ ENQ-ACK ]
[ SOFTWARE ] Handshake using the application program
Sets the communication speed to [ 300 ], [ 1200 ], [ 2400 ],
[ 4800 ], [ 9600 ], or [ 19200 ].
The default setting is [9600].
Sets the parity bit to [ NONE ], [ EVEN ], or [ ODD ].
The default setting is [EVEN].
Sets the data bit length to [ 7_BITS ] or [ 8_BITS ].
The default setting is [7_BIT].
Sets the stop bit length to [ 1_BIT ] or [ 2_BIT ].
The default setting is [1_BIT].
Determines whether or not to enable EOP timeout.
The default setting is [ON] or [Enable].
Sets up the EOP timeout value within a range of 1 to 255
seconds. If a value greater than 255 is entered, the timeout value
will be set to 255.
The default setting is [10].
Enables [YES] or disables [NO] the output response.
This must be set to [ YES ] if the printer requires a response when
data is transmitted from the host to the printer.
The default setting is [ NO ].
Description
[HP-GL].
Handshake using the ENQ-ACK protocol
(HP-GL only).
(HP-GL only).