Loading Originals In The Scanner - Xerox 6030 User Manual

Loading Originals in the Scanner

This section explains how to load originals in the scanner.
•
Scanning will begin automatically if the [How to Start Scanning] parameter is
set to [Auto start] in the Custom Presets.
•
The scanning speed will differ based on the reduction and enlargement
settings.
•
Blank copies may print if the <Stop Document> key is pressed during
scanning.
•
Long documents (originals up to 15 m in length) can be scanned. Scanning
may stop if the document length exceeds 15 m.
•
A document jam may occur if pressure is applied to the top of the document or
if it is pulled during scanning.
•
When scanning originals that contain holes, insert the original so that the area
with the holes feeds in last. Jams may occur if the area with the holes feeds in
first.
Procedure
Refer to section "5.2 Setting up the System Presets" in "Chapter 5 Custom Presets/
Meter Check" for more information about setting up the [How to Start Scanning]
function.
1
2
Place the side of the original that is to be
scanned face down. Align the edge of the
original with the document insertion guide.
To prevent edge damage when scanning a delicate
original, move the document insertion guide
all the way to the right, and align the
right edge of the original with the
marking on the document table, not the
document insertion guide.
Gently push the front (lead) edge of the
document into the scanner. Immediately
after you hear the document feed motor
start, the document will feed a short
distance into the scanner and stop.
Continue to support the document until
the lead edge is held by the feed rollers.
The document may jam if it is released
too soon.
Attempting to correct document
misalignment during a scan may cause
a jam.