Changing Output Roll Media For An Entire Job - Xerox 6030 User Manual

Changing Output Roll Media for an Entire Job

By setting the [Output Option] [Size] selection to [AUTO], the output media is
determined by the settings in the logical printer's [Media mapping] table. If a media
mapping table is prepared for each job, the output roll media can be changed for each
job.
For example, if an A1 roll and an A2 roll are loaded in the machine, and the A2 roll is to
be used for printing the A2 size (Job1) job, and the A1 roll media to be used for printing
(Job2), which is also in A2 size, the mapping table is set up as follows.
[PLT01H] logical printer settings
Image Size
In this example, (Job1) is specified to use logical printer [PLT01H], which will output
the job on the A2 roll media.
(Job2) is specified to use logical printer [PLT02H] and rotate the job 90 degrees to print
on the A1 roll media.
Job1
Job2
Media Size
A0 A0
A1 A1
A2 A2
A3 A3
A4 A4
Logical printer
A2
[PLT01H] specified
Logical printer
A2
[PLT02H] specified
Rotated by
90 degrees
[PLT02H] logical printer settings
Image Size Media Size
A0
A1
A2
A3
A4
Output on the
A2 roll media
Output on the
A1 roll media
A0
A1
A1
A3
A3