Renfert EASY view+ Translation Of The Original Instructions For Use page 32

1 Introduction
After initial start-up, check whether a newer software version is available for the
en
EASY view+. The version number of the software installed on your EASY view+
is displayed on the bottom right of the screen after switching on (see Chap. 5.1).
Software updates are available on our website at www.renfert.com/p918.
Enter the following item number: 2400 3000�
These instructions describe the range of functions of EASY view + up to and including version V1�021�
1.1 Symbols used
This manual contains symbols also found on the appliance itself with the following meaning:
Danger
Immediate risk of injury. Consult accompanying documents!
Electrical current
This indicates a risk of injury due to electrical current.
Caution
Risk of damage to the unit if the instruction is not followed.
Notice
A general notice that improves and eases use.
The appliance complies with applicable EU directives.
This product complies with the relevant UK legislation.
See UKCA Declaration of Conformity in the Internet under www.renfert.com
Within the EU, this device is subject to the provisions of the directive 2002/96/EC
(WEEE directive).
► List, special attention
• List
- Subordinate list
⇒ Instruction / required action / entry / order of tasks:
You are prompted to perform the specified action in the given order.
♦ Result of an action / reaction of the device / reaction of the program:
The device or program responds to your action, or because a particular event occurred�
Other symbols are explained when displayed�
2 Safety
2.1 Correct use of the unit
The system is used for digital stereo-magnification in 2D and 3D in real-time and for documentation.
2.2 Unapproved Use
Only spare parts and accessories supplied or authorized by Renfert GmbH may be used with this prod-
uct. If other spare parts or accessories are used, this could have a detrimental effect on the safety of the
device, increase the risk of serious injury and lead to damage to the environment or the device itself�
2.3 Ambient conditions for safe operation
The appliance should only be operated:
• indoors,
• up to 2,000 meters above sea level,
• at an ambient temperature of 5 - 35 ºC [41 - 95 ºF] *),
• at a maximum relative humidity of 80 % at 31 ºC [87�8 ºF], linear reduction up to 50 %
relative humidity at 35 ºC [95 ºF] *),
• with mains electricity supply provided that the voltage fluctuation is within 10 % of the rated value,
• with Pollution Degree 2,
• with Overvoltage Category II�
*) The unit can be used at a temperature of 5 - 30 ºC [41 - 86 ºF] and at a humidity of up to 80 %� At temperatures of
31 - 35 ºC [87�8 - 95 ºF] the humidity must reduce proportionately to ensure that the unit can be operated (e�g� at
33 ºC [91,4 ºF] = 65 % humidity, at 35 ºC [95 ºF] = 50 % humidity)� The unit should not be operated at tempera-
tures above 35 ºC [95 ºF]�
- 4 -