Table of Contents
Advertisement
5.
Tilt the SIMM towards the locking tabs using equal
pressure at the ends of the SIMM until it locks into the
socket.
Clip
Replace any cables or boards that may have been
6.
removed.
Replace the system unit cover.
7.
VIDEO UPGRADE
Upgrade the video memory by adding two 256-KB by 16-
bit video DRAM modules as follows.
Remove the system unit cover as previously described.
1.
Locate the video DRAM sockets (see "Option
2.
Installation Procedures" earlier in this chapter).
If any expansion boards are obstructing your view of the
sockets, remove the boards (see "Removing an
Expansion Board").
3-22 Installing Options
Notched End of SIMM
Inserting the SIMM
Advertisement
Table of Contents
