Expansion Board Removal - NEC POWERMATE P - SERVICE MANUAL 1995 Service And Reference Manual

3-8 Option Installation
4. Hold the board by its edges and insert it into the expansion slot. Align full-size
expansion boards with the guide rail at the front of the system unit.
Press the board firmly into the expansion slot connector. You might have to gently
rock the board from side-to-side to seat it into the connector.
Insert the screw removed earlier to secure the expansion board to the support
5.
bracket.
Figure Section 3-5 Inserting the Expansion Board
6. Attach any signal cables required by the expansion board.
Replace the system unit side panel (see "Replacing the Side Panel" in this section).
7.

Expansion Board Removal

1. Remove the system unit side panel (see "Removing the Side Panel" in this
section).
2. If you have any cables connected to the board that you need to remove, label the
connectors before you remove them.
3. Remove the screw that secures the board to the support bracket (see "Expansion
Board Installation" in this section).
Pull the board out of the connector. You might have to gently rock the board
4.
from side-to-side to release it from its connector.
Replace the system unit side panel (see "Replacing the Side Panel" in this section).
5.