Serial Devices; Speakers - NEC POWERMATE P - SERVICE MANUAL 1995 Service And Reference Manual

Serial Devices

Make sure the power to the system unit and serial device are off.
1.
2. Connect one end of the serial cable to one of the two serial ports on the rear of
the computer.
3. Secure the cable with the screws provided.
4. Connect the other end to the serial device.
Figure Section 3-20 Connecting an RS-232C Cable

Speakers

Connect the speakers to the system unit as follows.
Locate the speaker with the control knobs. This is the right speaker.
1.
NOTE: Before connecting a serial device to the
system, be sure that you have set up the serial
device correctly. Follow the setup instructions
that come with the option.
Option Installation
Serial
Port 1
Serial
Port 2
3-29