NEC POWERMATE P - SERVICE MANUAL 1995 Service And Reference Manual page 62

If the Administrative Password is in effect and Setup is entered with the User Password
only the following fields may be changed.
n
System Date
n
System Time
n
User Password
n
Security Hot Key
n
Unattended Start
n
Power Management Hot Key
The Security Submenu lets you check or change the following password parameters.
n
User Password
This field allows you to enable a user level password during POST and to enter
Setup. When both the "User Password is" and "Administrative Password is" are
"Enabled," only the Administrative Password gives you full access to all Setup
fields. This field can be either "Enabled" or "Disabled," the default is "Disabled."
n
Administrative Password
This field allows you to enable a administrative level password during POST and
to enter Setup. When both the "User Password is" and "Administrative Password
is" are "Enabled," only the Administrative Password gives you full access to all
Setup fields. This field can be either "Enabled" or "Disabled," the default is
"Disabled."
Set User Password and Set Administrative Password
Enable either or both the User or Administrative Passwords and a dialog box with
the following prompts appears. Passwords are not case sensitive.
NOTE: You can enter the Setup program with
either a User or Supervisor password. However,
more Setup choices are available with the
Supervisor password.
NOTE: If neither the User or Administrative
Password is Enabled,
"
Security Hot Key fields are not displayed.
Setup and Operation
the Unattended Start and
"
2-25