Speaker Assembly Removal; 1/2-Inch Diskette Drive Removal - NEC POWERMATE P - SERVICE MANUAL 1995 Service And Reference Manual

Speaker Assembly Removal

Remove the speaker per Figure Section 5-11 and the following steps.
1. Remove the side panel as previously described.
Remove the board edge guide/fan assembly as previously described.
2.
Unplug the speaker from its connector on the system board (see Appendix A for
3.
connector assignments).
Slide the speaker out from the four speaker tabs.
4.
To Connector
on System Board
5. Remove the speaker from the system unit.

3 1/2-inch Diskette Drive Removal

Remove the 3 1/2-inch diskette drive as follows.
1. Remove the side panel as previously described (see "Side Panel Removal").
Unplug the diskette drive power cable and signal cable from the diskette drive
2.
(see Figure Section 5-13).
Front of System
Uniit Chassis
Figure Section 5-11 Speaker Tabs
NOTE: When reinstalling the diskette drive,
note that all power cables are keyed to fit only in
the correct position. The red edge of the diskette
drive signal cable is positioned as shown.
Repair 5-9
1 of 4
Tabs