Replacing The Side Panel; Adding Internal Options - NEC POWERMATE P - SERVICE MANUAL 1995 Service And Reference Manual

4. From the rear of the system, position one hand on the protruding handle and the
other hand under the side panel and slide the panel toward the rear about one
inch.
5. Lift the side panel away from the system unit.
To replace the side panel, see the following procedure "Replacing the Side Panel."

Replacing the Side Panel

Position the side panel on the side of the system unit about one inch back from the
1.
front panel. Turn off and unplug the system unit.
Insert the tabs along the inside top and bottom of the panel with the slots in the
2.
unit frame.
Slide the side panel forward to meet the front panel.
3.
4. Secure the side panel with the two panel screws removed earlier. Lock the system
with a padlock if you desire.
5. Connect the monitor, keyboard, mouse, and any other external options to the rear
of the system unit.

ADDING INTERNAL OPTIONS

This subsection provides instructions for installing the following options:
n
expansion boards
n
SIMM upgrade
n
processor upgrade
n
data storage devices
n
audio wave upgrade
CAUTION: To prevent damage to system
cables, carefully tuck the cables out of the path
of the side panel.
Option Installation 3-5