1/4-Inch Device Removal - NEC POWERMATE P - SERVICE MANUAL 1995 Service And Reference Manual

5-12 Repair
3. Remove the 3 1/2-inch drive bracket as previously described.
4. Remove the four screws securing the 3 1/2-inch drive to the bracket. Slide the
3 1/2-inch drive out of the bracket (see Figure Section 5-19).
Figure Section 5-19 Removing the 3 1/2-Inch Drive

5 1/4-Inch Device Removal

Remove a 5 1/4-inch device (CD-ROM reader or other device) from the 5 1/4-inch device
cage as follows.
1. Remove the side panel and front panel as previously described.
2. Disconnect the device signal and power cables from the inside of the system unit.
(If removing a CD-ROM reader also disconnect the audio cable.)
Remove the 51/4-inch device by releasing the guide rail tabs and slide the device
3.
out from the front of the system unit.
NOTE: The 5 1/4-inch devices are installed with
drive rails.