Figure 2-1. Cd Drive Jumper Setting - HP Visualize J5000 - Workstation Handbook

CD Drive (Optional) Configuration
The optional CD drive connects to the ATAPI (IDE) interface in the CD drive bay
backplane within the J5000 and J7000 workstations via a 40-pin ribbon cable, a 4-pin
audio cable, and a 4-pin power cable. No interface addressing is required for the CD drive.
However, as shown in Figure 2-1, the CD drive should have a jumper set on the C SEL
(Cable Select) selection pins. (The CD drive should ship from the factory already jumpered
for C SEL.)

Figure 2-1. CD Drive Jumper Setting

Jumpered
for C SEL
See the section titled "CD Drive (Optional)" on page 93 for details on installing a CD drive.
Chapter 2
Field Replaceable Unit (FRU) Configurations
Configuration
35