Long-Term Storage - OREC RM953 Instruction Manual

Reference:
1) The tightening torque for the hard lock nut is "800 kgf·cm" (78.4 N·m). As a guide, use a
30 cm long box wrench (size 22) and tighten it with a force of about 32 kgf or more.
2) A torque wrench is required to check the tightening torque. We recommend that you check
the tightening force of the above torque at a dealer in advance.
3) If you use it in a place containing dry soil or sand, check the Blade frequently because the
Blade will wear quickly.
4) We recommend that you have a spare Blades and a set of necessary parts for installation
beforehand.
5) Be careful not to lose the knife collar when changing Blades.
6) If the gauge (recess) on the back of the Blade setting bolt is worn, replace it.

5.5 Long-term storage

5.5.1 Preparation for long-term storage
Long-term storage with fuel left in the fuel tank or carburetor may cause problems such
as poor starting or reduced output.
1) Since this product uses gasoline as fuel, it is dangerous to ignite for leak fuel, or smoke
or bonfire near the product.
2) For storage, place the machine horizontally on a flat, well-ventilated place.
3) Wait for the engine and muffler to cool after stopping the engine (about 5 minutes or
more) before draining gasoline from the fuel tank and covering the machine.
3) For safety, please remove the key and store it as the administrator of this product.
4) Do not store the removed fuel in a plastic tank or use the oxidized fuel that has been
stored for more than 3 months as it may cause troubles.
5) Reinstall the removed hoses, clips, and drain bolts.
wear
- 52 -
5. 点検・整備・調整