Inspection Before Work; Check Engine Oil - OREC RM953 Instruction Manual

３. Inspection before work
●Before starting work, check "1.2 Before Starting Work" and check the following "Before
starting work checklist" and
to "7.1 Periodic inspection table".
※If you have any questions or problems, please be sure to contact the dealer where you
purchased the product.
Engine oil
Engine
Air cleaner
Blade (Knives)
Brake (Applicable product)
Tire (crawler)
Machine
Levers
Body
Covers
HST oil (Applicable products)
1) Be sure to stop the engine before Checking, Refueling, Adjusting or Servicing .
2) When starting the Engine and Checking the operation of the Driving clutch lever etc.,
Check the safety of each Lever position and the surrounding of machine.
3) Make sure you understand the warning markings on the Machine.

3.1 Check engine oil

oil plug
insert oil plug without screwing、Check the amount of oil. If there is no oil mark between
the upper and lower scale lines, add engine oil so that the oil reaches th e upper scale line.
Be sure to perform the pre-operation inspection according
Pre-operation checklist (summary from regular checklist)
Item
Oil gauge
Upper
Lower
Inspection contents
Check "oil amount and dirt" <Refer to 3.1>
Check for "dirt" and clean <5.2.1>
<Refer to 5. Inspection and maintenance>
"1" bolts and nuts are loosened or dropped
"2" Deformation, wear, interference
"3" Smooth movement or Sticking
"4" Remove foreign matter such as garbage, grass
and straw
Check "oil amount and dirt"
① Level the machine and remove
the oil gauge.
② The tip of the Oil plug is an
oil gauge. Wipe the gauge part
with a cloth、Place the engine
horizontally、Briggs Engine : screw
in oil plug、Kawasaki Engine only
- 18 -
3.作業前点検