How To Load And Unload - OREC RM953 Instruction Manual

1) Always put the drive clutch lever to the "ON" position, except when manually moving
the machine.
2) For safety, please manually move the machine with 2 people (one driving and one
supporting).
3) Do not move the Sub-Shift lever to the "N (neutral)" position on sloping ground.
It may cause slipping and is very dangerous.
Be careful not to touch mufflers and other hot parts when turning the driving clutch
lever on.

4.3 How to load and unload

1) Always stop the engine and keep the fuel cock in the "Closed" state when transporting
the machine. Spilled fuel can catch fire.
2) Also, do not tilt the machine more than necessary. Fuel may leak out.
Ramp Standards;
Make sure that your ramp is comprised of materials strong enough to comform ro the
following standards.
1) Length: 3.5 times longer than the truck's loading bed is high. (Less than 15 ° tilt angle
of the bridge)
Width: At least as wide as the wheel span of the machine.
Strength: Sufficiently strong enough to take the total weight of the machine and the
operator combined.
Surface: Use a ramp with a non-slip surface.
2) Do not stop in the middle of the ramp. Especially when restarting the machine upon
loading, there is a danger of the machine's front tires lifting off the ground. Please loead
and unload at a low speed.
3) Please use a truck without a canopy over the bed. When unloading, the operators may
collide with the canopy.
- 26 -
4.運転・作業のしかた