Fuel Inspection And Refueling - OREC RM953 Instruction Manual

1) If you want to check the engine oil after the engine is running, wait for "about 5 minutes
or more" after stopping the engine, and check the cooling condition of the muffler and
the engine itself.
2) Be sure to check the engine oil level before starting, as excessive or insufficient engine
oil may cause a malfunction.
3) The engine oil is of high quality above SF / SG / SH / SJ grade, use "10W -30" oil, and do
not use commercially oil additives.
4) After replenishing, securely tighten the oil gauge. If tightened loosely, engine oil may
leak out.
「Recommended oil」

3.2 Fuel inspection and refueling

Fuel gauge
① Set the horizontal, remove the filler cap and check the
amount of fuel from the filler.
② Refuel as soon as the fuel gauge approaches the
"E" position.
③ Do not put fuel above the middle of the filter.
It may cause fuel leakage on uneven roads and slopes.
Leaked fuel will be discharged to the front of the tank.
Tank Front
Clean up any spills fuel.
④ After refueling, securely tighten the fuel filler cap.
※ Fuel gauge is a guide. Keep the fuel up to the middle
of the filter and be careful not to overfill it. If it spills,
wipe it clean. Especially when using on sloping ground,
use below the bottom of the filter. There is a risk of fuel
leaking out due to slope.
〈Fuel used: Unleaded regular gasoline〉
- 19 -
3.作業前点検