Table of Contents
Advertisement
B&S
Foam Element
Paper Elemnt
Reference；
1) If the paper element is extremely dirty, replace it with a new one, or wash it with soapy
water and wash it with water, and dry it thoroughly.
element when cleaning.
2) Be careful when Tapping the paper element please do not make a damage the filter paper.
3) When drying, blowing the hot air may damage the adhesive part of the paper element.
Dry with low warm air or let it natural dry.
4) Be sure to clean it frequently when using it in dusty work environment.
5.2.2 Checking and adjusting the spark plug
to 0.8 mm.
Reference；
1) Engine is used V-type 2 cylinder. Check and replace the two plugs at the same time, and
do not clean or replace only one side. It may cause engine malfunction.
2) When tightening, first lightly screw in with a hand and then use a plug wrench (until the
gasket touches the bearing surface).
Please note that if you tighten it with a plug wrench from the beginning, the threads may
be destroyed.
Do not test the spark plug ignition near the cylinder plug hole. It is dangerous to catch fire.
⑤ Wipe off any dirt inside the hose with a waste cloth and
reassemble.
Cleaning and replacing the air cleaner
Foam
Element
Paper Element
The element is easily torn.
① Remove the spark plug with a plug wrench, if there
is carbon on the electrode part "A", remove it with a
wire brush, and if it is wet, wipe it off.
② If the central pottery is cracked or if the electrodes
are worn, replace the spark plug with a new one.
③ Adjust the electrode gap "B" of the spark plug to 0.7
- 39 -
5. 点検・整備・調整
Cleaning
Before every time
Before every time
Do not pull or tumble the foam
Replacing
Every 100
hours
Every 100
hours
Advertisement
Table of Contents
