OREC RM953 Instruction Manual page 34

1) Operators must wear long-sleeved shirts and long pants with hemmed sleeves, non-slip
boots and hats or helmets, dust-proof glasses, and protective gloves.
2) Remove foreign objects such as stumps, stone chunks, wire, empty cans, and broken
sticks before operation.
3) Always use a bridge when going over steps of about 70 mm or more, as high speeds can
cause the machine to rollover accident or malfunction. When over a step, be sure to go
forward at low speeds and the tires ride into over the step perpendicularly. High-speed
overtaking, even over a step of less than 70 mm, is not only a cause of malfunction, but
is also very dangerous.
4) If the front wheels fall into a hole or ditch, do not turn the steering wheel. After stop the
engine, lift the product up to escape. Uncontrolled operation of the steering wheel may
cause malfunction of the product.
5) Collision of the front wheels with stumps, curbs, etc. while driving or working may cause
malfunction.
6) When working under branches or on slopes, please work with the utmost care to avoid
accidents such as being caught between branches or rollover accidents.
7) The knife rotates at high speed, please be careful not to injure yourself.
8) Operate the knife clutch lever slowly.
9) If the knife clutch lever is suddenly set to the "On" position at the lowest cutting height
(around 10mm), a sudden overload will lead to early breakag of the mowing belt.
10) When disengaging the knife clutch, be sure to return the knife clutch lever to t he "OFF"
position, then wait a few seconds (about 5 seconds) before turning the mowing height
adjustment lever to the "MOVE" position. Knife rotation may not stop immediately,
leading to scattering of stones and other foreign objects.
11) Take care to prevent grass, leaves, etc. from accumulating on the engine. Accumulation
of these combustible materials may cause fire or malfunction.
12) If the machine stalls out frequently because of the amount of grass, slow down the
speed, or raise the cutting height and cut several times.
Reference；
1) When you use the machine for the first time, please choose a flat surface with no foreign
objects such as stones, and cut straight and slowly so that you become familiar with its
operation.
2) Grass clippings are discharged from the right rear of the machine. As obstacles on the right
may cause damage, please position trees, pillars, walls, and other obstacles on the left side
of the machine (turn to the left if the cut is circular).
- 31 -
4.運転・作業のしかた