Regarding Long-Term Storage - OREC AHRC 663 Operating Instructions Manual

Regarding Long-Term Storage

If you do not use the machine for more than 30 days, please carry out the following procedures for maintenance.
If the machine is not stored properly, there is a danger of fuel spoilage, the machine failing to start, or trouble
running the machine.
WARNING
Please work on the machine in a place that is well ventilated. Fuel gas can fill a room and cause accidents.
Before storing the machine, switch off the engine and remove the spark plug cord.
Store the machine on a flat surface in a room that is cool, well ventilated and protected from the outdoor
elements.
When removing fuel, do not work anywhere near lit cigarettes, naked flame or any sources of ignition. There
is a danger of the machine catching fire.
Before removing fuel, wait for the engine and muffler to cool down sufficiently before you touch them. There
is a danger of burns. Take care to handle removed fuel according to local laws and regulations.
If you neglect to clean accumulations of weeds and dust from inside the machine, blockages can cause
the engine to overheat, burn or catch fire the next time you use the machine.
Carburetor
Drain plug
Fuel valve
5. Refuel and relubricate all parts that need fuel, oil, or grease.
6. Engage the parking brake and s
and protected from the outdoor elements.
7.
Put a cover over the machine to keep dust out.
NOTICE
It is relatively easy to wash out waste weeds, etc, from inside the blade cover if you use a pressurized
water hose and clean the waste out before it dries. At this time, make sure that water only contacts the
cover, not the engine's electrics, carburetor, air filter, and muffler exhaust opening. This can damage
the engine's ability to start.
During storage, check the tire pressure periodically and add air as necessary.
1. Loosen the drain bolt, drain the fuel from inside the carburetor.
Remove fuel from fuel valve and fuel tank. In a dry location store
the machine.
2. Use a cloth to wipe away any traces of oil from the outside of the
engine and machine body.
3. Replace engine oil.
Refer to page 26 for how to replace the engine oil.
4. Be sure to clean each part thoroughly.
In particular, clean out accumulations of weeds and dust from such
places as the recoil starter, air filter, carburetor, and inside the belt
cover. Clean any rust from exposed parts and apply anti-corrosion
paint.
tore the machine on a flat surface in a room that is cool, well ventilated
36