Table of Contents
Advertisement
2) After adjustment, make sure the parking brake pedal is "locked" and the sub gear shift
lever is in the "neutral" position. and the machine dose not move back and forth when
pushed it, or it dose not move on slopes.
Please ask your dealer for the following work.
1) The brake will also wear out. If the above method cannot be adjusted, the brake shoes
may be worn. For safety, please replace it regularly when the usage time does not exceed
100 hours. When replacing, also replace the U nut and cotter pin at the same time.
2) Adjust the play of the brake spring is about 2 to 4 mm, and after adjusting, securely
tighten the lock nut.
3) The Driving and Blade belt will also be consumed. If it is abnormal, replace it with a new
one. First adjustment is 10 hours and then every 50 hours thereafter.
⑥ Adjusting the Speed shift lever (change pedal)
B
A
A
Turnbuckle
Reference；
Adjustment of the speed shift lever (change pedal) is not necessary except when
disassembling the mission etc. Adjust if the position of the shift lever is not aligned with
the guide display.
⑦Blade clutch wire adjustment
Adjust Nut
Lock Nut
B
①Move the Speed shift lever to the neutral "N" position.
② Adjust by turning the turnbuckle connected to the shift
lever.
③ When moving a little in the forward direction.
④ When moving a little in the reverse direction.
Adjust with the adjustment nut of the Blade clutch wire,
referring to the photo on the left.
①
When the knife belt tension is weak.
②
When the Blade belt is tight.
Spring extension
①
At the highest cutting height, approximately
A
L=125 mm(RM953) , 120mm(RM883)
- 45 -
5. 点検・整備・調整
...Turn the turnbuckle in direction A.
...Turn the turnbuckle in the B direction.
...Adjust nut in direction B....
...Adjust nut in direction A...
Advertisement
Table of Contents
