OREC RM953 Instruction Manual page 25

Change pedal
Brake stopper
Brake pedal
Blade clutch lever
Cutting Height adjustment Lever
Reference；
The Blade clutch lever is linked to the cutting height adjustment lever. Move the cutting
height adjustment lever to the "move" position and the Blade clutch lever will also return to
the "OFF" position.
Choke lever
Throttle lever
③ Lock the brake stopper while stepping on the brake pedal.
If the shift lever is in a position other than the neutral
"N" position, return it to the neutral "N" position.
④ Set the blade clutsh lever to the "OFF" position, and the
cutting height adjustment lever to the "move" position.
Closed
⑤ After confirming that the shift lever is in the neutral "N"
position, pull the Choke lever.（The state where the lever
is pulled is the "Closed" position, and the state where the
lever is pushed is the "OPEN" position. ） (This is not
necessary if the engine is warmed-up.)
⑥ Move the throttle lever to the middle position between
high speed and low speed.
⑦ Insert the key into the engine switch and continue turning
the key from the "RUN" position to the "START" position
to start the engine.
⑧ Release the keys as soon as the engine starts.
Automatically returns to the "DRIVE" position.
⑨ After starting the engine, push the choke lever back to
the "OPEN" position and return the throttle lever to the
"low speed" position and warm up for a while.
- 22 -
4.運転・作業のしかた