Table of Contents
Advertisement
⑨ Sub shift lever (Only RM953)
The "high speed" side is for "moving". Please do the mowing work only on the "low speed"
side. For safety, work on a sloping ground at 10° or less. For operation, be sure to insert
the lever to the cutout part of the gear shift guide at each po sition. In the "neutral"
position, you can push the machine without the engine power.
Sub shift lever operation is should be stopped the machine and insert it in to cutout position.
Operation while driving or insufficient gear shifting may cause slipping due to gear loss, which is
extremely dangerous. Also, please be sure to take two or more person to push the machine. Be sure
to do the mowing work only on the "low speed" side. On the "high speed" side, the speed is high, and
there is a delay in the risk avoidance measures in case of an emergency, which is dangerous. (*Product
with sub shift lever)
⑩ Differential lock lever
Normally, use this in the "off" position. When working on a gentle slope or on a soft ground,
or when one side of the rear wheel is slippery and it is difficult to go straight, or when loading
/ unloading to / from a truck, set the diff lock lever to the "ON " position to set both sides of
the rear wheel tires are directly connected, which improves straightness.
If you use a flat ground, the turning radius will be large, tires will be worn out, and it may
cause mission damage.
⑪ Parking brake pedal
In case of an emergency, if you fully depress the pedal, the brake will be applied, then machine
will be stopped, and the shift lever will be returned to the "neutral" position. For normal stop
operation, always use the change pedal or shift lever to stop. keeping the pedal depressed and
lock with the brake stopper, it will be a parking brake. The lock is released when you step
Parking brake pedal
Brake Stopper
⑫ Blade replacement cover
further. The engine cannot start unless the pedal is
depressed (locked).
- 15 -
２. 各部の名称とはたらき
Advertisement
Table of Contents
