⑧Diff-Lock Wire Adjustment; ⑨Safety Switch - OREC RM953 Instruction Manual

③ The lowest cutting height is about
L=135 mm(RM953) , 130mm(RM883)
⑧Diff-lock wire adjustment.
①
Adjust Nut
B
Lock Nut
Reference；
Adjust the play at the lever base is about 1 to 3 mm when the differential lock lever is in
the "OFF" position (released). Be sure to securely tighten the lock nut after each adjustment.
⑨Safety switch adjustment.
Highest cutting height：About L=125mm ~120mm
Lowest Cutting height.：About L=135mm~130mm
Refer to the photo on the left, adjust with the adjustment
nut of the diff-lock wire, and check if it operates properly
after the adjustment.
① If the differential lock is not work.
② If the differential lock is not released.
A
① Safety switches are located on the right side under the
seat bracket, the base of the cutting height adjustment
lever, and the bottom of the seat total three position.
② After adjusting the safety switch, tighten the lock nut and
return the seat to its original position.
③ Check the operation of the tip of the safety switch、and if
the movement is slow, apply a thin layer of grease spray to
the switch operating section. If it does not improve, replace
the safety switch.
L
...Adjust nut move to direction A...
...Adjust nut move to direction B...
- 46 -
5. 点検・整備・調整