No Fires・Fuel Supply; During Work; Precautions Of While Working - OREC RM953 Instruction Manual

(3) The parking brake is working on the 2m bridge which hooked it on the bed of a light truck.
7) Before starting work, be sure to remove the cooling air intake of the engine, the clogging near the
cylinder, especially the high temperature around the exhaust pipe and the debris accumulated on
the machine. It may cause engine burn-in or fire.
Also, clean is not only the outside but also the inside of the air cleaner and the inside of the HST
fan cover (applicable product) at the same time.
1.2.3 No fires・Fuel supply
1) No fire is allowed around the machine, not only during work and refueling.
Do not use cigarettes, bonfires etc., naked flames etc. absolutely near the machine.
2) After stopping the engine, please refuel after the muffler temperature drops sufficiently.
3) For refueling, if there is a fuel level upper limit mark, please do not exceed the mark.
Please remove the Fuel when it is too much to be below the mark.
Also, be sure to wipe spilled fuel.
4)Please do not refueling when the body is charged with static electricity.
There is a possibility of ignition due to vaporize gasoline, there is a big risk of burns and fire.

1.3 During work

1.3.1 Precautions of while working

1) Please try to driving safely, and do not start suddenly, stop suddenly and do not turn
abruptly.
2) Please do not work in an unreasonable posture and take a rest within 1 -2 hours
according to your physical condition.
3) To prevent people (especially children) and pets entering the working area (within a
radius of 10 m), set a standing tag or guard rope to indicate that the Grass cutting
work is processing in inside and do not approach within a radius of 10 m.
When a person or pet approaches, stop work immediately and stop the engine.
4) Do not put flammable or dangerous materials around while driving. Also, the exhaust
muffler becomes hot. There is a risk of burns if your hands are touched when operating
the machine or immediately after finishing work.
5) For work on the slope, please use the slope of 20 ° or less. Please do it in the lateral
direction (contour direction) rather than the vertical direction. If the machine is used at
an inclination of 20 ° or more, the machine may overturn and become the underla y of
the machine.
6) Please take precaution to prevent slippage well. But although please do not work in
slippery places.
- 6 -
1. ご使用の前に