Table of Contents
Advertisement
Installation and operating manual
WARNING
WARNING
7.2 Connection work
The following prerequisites must be met before carrying out electrical installation work, and all preparation
work must be completed first.
Tool
•
1.5 mm slotted screwdriver
•
Wire stripper
1.
A protective contact socket is installed within reach (<3 m (19 ft)) of the place of installation of
the QWIK-PURE
2.
The fusing for the protective contact socket is adequately dimensioned for the corresponding
power consumption.
3.
Assembly of the QWIK-PURE
Improper electrical installation!
Improper electrical installation of the product and the accessories can lead to
personal injury and damage to property as well as impair operation when working
on the product and accessories.
•
Check all plug connections are correctly fitted.
•
Avoid danger of tripping by routing the cables accordingly.
•
Avoid mechanical stress on the cables.
Ingress of moisture or foreign objects!
Water and foreign objects can get into the opened FRC control unit or into the
opened electrical connections if electrical connections are disconnected or if
the FRC control unit is opened. The ingress of water or foreign objects can result in
accidents, personal injury and property damage, and problems during operation.
•
Protect the FRC control unit and the electrical connections from splash water
and moisture.
•
Open the FRC control unit and disconnect the electrical connections in a dry
location only.
•
Do not insert any foreign objects into the openings of the FRC control unit.
•
Keep all contact surfaces and openings free of impurities and moisture.
Preconditions
•
Cable for the power supply
•
Modbus cable
•
Included connector
Preparatory work
iCS.
®
iCS is complete.
®
Material
QWIK‑PURE
Protective equipment
To be worn at all times:
iCS
®
69 | 132
Advertisement
Table of Contents
