Modification Of Interface Parameters - Beko QWIK-PURE CS Installation And Operating Manual

QWIK‑PURE ® iCS

3.5.3.3 Modification of interface parameters

This procedure is used to change interface parameters required for communication.
1. Write the value 0xAC1D (decimal: 44061) to the holding register 0x1392 (decimal: 5010).
2. Write the parameter to the holding register 0x07D0 (decimal: 2000).
Description / explanation
HighByte: See the following table
LowByte: Modbus server address 1 ... 246
Example value: 0x070A (decimal: 1802)
Interface parameters see table Index 0x07 (decimal: 7)
Client address 0x0A (decimal: 10)
4. To save the settings, write the value 0xBA5E (decimal: 47710) to the holding register 0x139C
(decimal: 5020).
5. Switch the product off and on again.
0 The changes take effect approx. 10 seconds after the restart.
Parameter
Baud
Selection Rate
[Bd]
0x00 4800
0x01 4800
0x02 4800
0x03 9600
0x04 9600
0x05 9600
0x06 19200
0x07 19200
0x08 19200
0x09 38400
0x0A 38400
0x0B 38400
30 | 132
HighByte
Parity Stop Bit
No 2
Even 1
Odd 1
No 2
Even 1
Odd 1
No 2
Even 1
Odd 1
No 2
Even 1
Odd 1
Parameter
Baud
Selection Rate
[Bd]
0x0C 57600
0x0D 57600
0x0E 57600
0x0F 76800
0x10 76800
0x11 76800
0x12 115200
0x13 115200
0x14 115200
Installation and operating manual
HighByte
Parity Stop Bit
No 2
Even 1
Odd 1
No 2
Even 1
Odd 1
No 2
Even 1
Odd 1