Table of Contents
Advertisement
Installation and operating manual
4.8 Assembly conditions
Observe the following conditions when setting up and selecting the place of installation:
•
The place of installation must meet the following conditions:
0 Indoors
0 Protected from mechanical loads
0 Protected from splash water
0 Protected from direct sunlight and areas exposed to heat sources
0 Protected from frost
0 Outside of hazardous locations
•
The setup area must be level (gradient ≤18 mm/m (1/3 in/ft)) and smooth.
•
The setup area's load capacity must be suitable for the maximum operating weight of the
QWIK-PURE
iCS (refer to section "4.1 QWIK-PURE® iCS operating parameters" on page 42).
®
•
The setup area must be sealed, or a suitable spill protection basin must be in place.
0 In the event of damage, no untreated condensate or oil may get into the sewer system or the soil.
0 All locally applicable standards and regulations regarding the protection of bodies of water must be
complied with.
•
Bumper guards must be installed if the product is being set up in the vicinity of traffic routes.
•
A compressed air supply line provided by the customer must be available and equipped with a
maintenance unit (pressure reducer and filter).
•
The cross-sectional area of the condensate collection line must be greater than G1" (Ø = 25 mm).
•
Route the condensate collection line with a gradient ≥ 50 mm/m (2/3 in/ft) to the place of installation for
the QWIK-PURE
iCS.
®
•
The manufacturer recommends installing a P-trap at the wastewater connection in order to prevent
unpleasant odors.
•
The manufacturer recommends installing a 3-way valve at the tapping point on the condensate collection
line to divert the condensate inlet into a separate container during maintenance work.
50 mm/m
2/3 in/ft
Example image
QWIK‑PURE
iCS
®
51 | 132
Advertisement
Table of Contents
