Table of Contents
Advertisement
QWIK‑PURE
®
iCS
2.5.5 Transport and storage
Improper transport or storage can lead to personal injury or damage to property.
In order to ensure safety during the transport and storage of the product and accessories, observe the
following:
•
Handle the packaging, the product and accessories carefully.
•
Transport and handle the packaged product and accessories according to the labeling on the packaging
(observe attachment points for hoists, center of gravity and orientation such as holding vertically, do not
throw, etc.).
•
Use proper, functional transportation equipment and hoists.
•
Always adhere to the permissible storage parameters.
•
Store the product and accessories only outside of areas exposed to direct sunlight, heat sources and
splash water.
•
Empty the assembled product before transporting it.
2.5.6 Installation
The improper assembly or electrical installation of the product and accessories may result in personal injury
and damage to property and impair operation.
For safe assembly and electrical installation, observe the following:
•
Assemble the product and all the parts, accessories and materials used free of mechanical stress.
•
Check all plug connections are correctly fitted.
•
Avoid stumbling risks by routing cables and hoses accordingly.
•
Avoid mechanical stress on the cables.
•
Fasten and fix all hoses in such a way that they cannot make any percussive movements.
•
Install the inlet and drain lines for condensate and compressed air as fixed pipes.
2.5.7 Maintenance
Improperly carrying out maintenance and repair work may result in serious injury or death.
For safe maintenance and repairs, observe the following:
•
Before starting work, bleed the pressurized product and accessories and lock them out so that they
cannot be pressurized by accident.
•
Before starting work, cut off the condensate feed to the product and divert the incoming condensate into
a separate container.
•
Before starting work, de-energize the product and accessories from the power supply and lock and tag
them out.
•
Only use materials approved for the respective application.
•
Use only suitable tools in perfect condition.
•
Only use cleaned pipes and hoses that are free of dirt and corrosion.
•
Do not use abrasive or aggressive cleaning agents or solvents that could damage the external coating (e.g.
labels, type plate, corrosion protection, etc.).
•
Do not clean or operate the device with hard or pointed implements.
•
Make sure to only use the specified materials and fluids for cleaning.
•
Comply with all applicable hygiene regulations and regional and internal hygiene rules and standards.
12 | 132
Installation and operating manual
Advertisement
Table of Contents
